Ubiquiti Unifi firmware 4.0.26.10049 for UAP/USW has been released Firmware changes since 4.0.25
[nanoHD/IW-HD] Add support to display which client STAs support Fast Roaming.  [nanoHD/IW-HD] Fix a crash when running RF Environment scanning. [nanoHD/IW-HD] Fix a null pointer access issue. [UAP] Add initial RFC-5176 support.* [UAP] Add U-NII-2C support for Panama country code.  [UAP] Fix and improve User Groups support.  [SEC] Fix CVE-2019-8912. [HW] Miscellaneous bug fixes and improvements.
*controller support pending.
 
NOTES:
You may start to see EVT_AP_RestartProc events in the controller log. If you see these, please report if there is anything specifically in your setup that triggers the events. The processes restarting is not new, but the reporting of the restarting is, and we are using these reports to clean up these issues. Any US-XG-6POE upgrading from 4.0.2 or earlier will take a long time to upgrade. Don't be surprised if your switch is unavailable for 5-10+ minutes as 4.0.3+ also updates the PoE firmware to improve PD compatibility.
1st gen UAPs may require extra steps when upgrading from firmware 4.0.3. You can try disabling all WLAN groups, and then running the upgrade. Devices that are seemingly "stuck" on 4.0.3 may require TFTP recovery to upgrade from that firmware.
All supported 1st gen APs need to be on a minimum of 4.0.10 prior to upgrading to this firmware. Controller 5.10.3+ will force an upgrade to 4.0.10 prior to upgrading to this release (only if your device isn't running 4.0.10 already).  Firmware for 1st gen UAPs are being skipped while we investigate the various reported issues. 
 
      07-05-2019 09:09     Reacties ( 0 )
Reacties (0)

Geen reacties gevonden.